Canoga-perkins 9140 Four-Port SNMP Managed Fast Ethernet Switch Instrukcja Użytkownika Strona 32

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 99
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 31
3-6
3.2.3 100BASE-FX Single Mode Module
This is a plug-in module, which contains the 100BASE-FX Single Mode interface Figure 3-6.
The interface components are the following:
SC/ST connector
Port LEDs
Tx Transmit (Green)
Lnk Link (Green)
Col Collision (Yellow)
Fdx Half/Full-Duplex (Green)
Rx Receive (Green)
Rmtf Remote fault indication (Red) [Managed Units Only]
Par Partition/Disable (Red)
Llf Link Loss Forwarding/Enabled (Green) (Disabled on 9140)
Connectors: Edge connector to the main board unit
Figure
3-6. 100BASE FX Single Mode Module.
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted: Bullets and Numbering
Formatted
Przeglądanie stron 31
1 2 ... 27 28 29 30 31 32 33 34 35 36 37 ... 98 99

Komentarze do niniejszej Instrukcji

Brak uwag